The Heirloom Laguna Deux - Gone
- Hooli
- Self Appointed Internet God
- Posts: 33605
- Joined: Mon Apr 08, 2019 9:25 pm
- Has thanked: 14375 times
- Been thanked: 11152 times
Re: The Heirloom Laguna Deux - Trouble lurking
Useless fact of the night - Unit construction Triumph motorbikes have the same style of level control for gearbox oil, but you can do them cold.
Private signature, do not read
-
- It's S small i C
- Posts: 9382
- Joined: Sun Apr 28, 2019 8:59 am
- Has thanked: 1827 times
- Been thanked: 5407 times
Re: The Heirloom Laguna Deux - Trouble lurking
No change of topic because today, just after I pull into the drive and put it in park, it revved to 2k rpm and stuck there. Then Mrs Renault blurted out that I need to take it to my local Renault dealer
These are the stored errors:
Clearing the codes bought it back to normal. I believe it's a connector under the battery box that can get dirty/fail.
Arses. Could do without this just right now.
At least the gearbox hasn't done the thing again where it forgets it is a gearbox and looses all its heads. What's the commonality between those two events? Completely unrelated but both times the climate control backlight started working again...
These are the stored errors:
Clearing the codes bought it back to normal. I believe it's a connector under the battery box that can get dirty/fail.
Arses. Could do without this just right now.
At least the gearbox hasn't done the thing again where it forgets it is a gearbox and looses all its heads. What's the commonality between those two events? Completely unrelated but both times the climate control backlight started working again...
-
- Prize Cunt
- Posts: 6336
- Joined: Wed Apr 10, 2019 6:31 pm
- Location: Big Al Granvia’s armpit.
- Has thanked: 718 times
- Been thanked: 2337 times
Re: The Heirloom Laguna Deux - Trouble lurking
It's a Laguna II so electrical problems are caused by seasonal events and the solar system.
GLWTS.
GLWTS.
- Hooli
- Self Appointed Internet God
- Posts: 33605
- Joined: Mon Apr 08, 2019 9:25 pm
- Has thanked: 14375 times
- Been thanked: 11152 times
Re: The Heirloom Laguna Deux - Trouble lurking
Check the ECU connections too.SiC wrote: ↑Thu Jan 23, 2020 6:40 pm No change of topic because today, just after I pull into the drive and put it in park, it revved to 2k rpm and stuck there. Then Mrs Renault blurted out that I need to take it to my local Renault dealer
These are the stored errors:
Clearing the codes bought it back to normal. I believe it's a connector under the battery box that can get dirty/fail.
Arses. Could do without this just right now.
At least the gearbox hasn't done the thing again where it forgets it is a gearbox and looses all its heads. What's the commonality between those two events? Completely unrelated but both times the climate control backlight started working again...
When mine did that it was after an ECU swap to match all the new security shite like steering locks.
I swapped back to the old ECU and even though the entire Internet says it won't work, it fixed it.
Private signature, do not read
-
- Posts: 13772
- Joined: Sun Apr 14, 2019 11:24 pm
- Has thanked: 1828 times
- Been thanked: 2715 times
-
- It's S small i C
- Posts: 9382
- Joined: Sun Apr 28, 2019 8:59 am
- Has thanked: 1827 times
- Been thanked: 5407 times
Re: The Heirloom Laguna Deux - Trouble lurking
Apparently our buyers are waiting for a new mortgage offer as getting a better rate. They are wanting to exchange before the 31st Jan, so they can give a month's notice on their rented place. Keeping fingers crossed, but given the set backs, I'm very pessimistic until we get the call from the solicitor that we have completed.
-
- Posts: 13772
- Joined: Sun Apr 14, 2019 11:24 pm
- Has thanked: 1828 times
- Been thanked: 2715 times
Re: The Heirloom Laguna Deux - Trouble lurking
If they exchange then you should be OK, not many folks drop out after that point.
Good luck
Good luck
-
- It's S small i C
- Posts: 9382
- Joined: Sun Apr 28, 2019 8:59 am
- Has thanked: 1827 times
- Been thanked: 5407 times
Re: The Heirloom Laguna Deux - Trouble lurking
Well if they do pull out after exchange, we'll get a 10% deposit at the very least and they'll get a legal case!
-
- It's S small i C
- Posts: 9382
- Joined: Sun Apr 28, 2019 8:59 am
- Has thanked: 1827 times
- Been thanked: 5407 times
Re: The Heirloom Laguna Deux - Trouble lurking
Took a look at this yesterday. Many report that the connectors under the battery box can become corroded and cause the throttle body issue.
Took the covers off the battery
Then the battery out
These weird bolt things were a pain to remove. Far too large for any normal screwdriver. I just bashed them around with a wood chisel.
Here is the prize! I assume when they mean connectors under the battery box, they mean the engine ECU connectors
The connectors and pins themselves look in good nick.
Also checked the throttle body connector and that was in good condition too. No flipping idea what caused it. The fault was from a complete throttle body fault on both resistive tracks. Maybe the throttle body is at fault? I don't believe these engines had an issue with them, only the connectors getting corroded.
I did notice that this loom wire was rubbing against the body.
Pulling off the insulation tape and having a closer look seemed to show it was still intact. I wrapped more tape around and used a bit of scrap Dolomite soundproofing material to provide a softer edge.
So I don't know what caused it. I wonder if there is a chaffed section on the engine loom somewhere.
Bit concerning really. Especially as the fault is to rev the engine to 2k and the gearbox to go into 3rd gear (limp home mode). Wouldn't be a pleasant experience it suddenly doing it at motorway speeds or especially if sat in traffic.
Also the intake air temperature sensor is broken. I'm not sure if I caught it or it was already on its way out and it fell to pieces when I was tugging the loom as I was inspecting it for any obvious damage. I took the sensor out entirely and there was broken plastic around the area. Currently the sensor has tigerseal around it to hold it in place. A new sensor is on order.
Upon restarting the car, it really struggled to start. When it did, it was extremely lumpy - almost misfiring. Also a ticking type noise. As the engine warmed up a bit, it's cleared up and seems to run fine.
I think it may have been some of the plastic from the Intake Air Temperature sensor being ingested by the engine? When I removed the sensor, I thought I got all the bits of plastic out of the hole but I wonder maybe some didn't. Only plausible explanation for the rough running. Oops!
I did try restarting it when it was stone cold and it starts happily now. So I don't think there is any ill effects. The plastic was quite brittle and pretty soft, so I can't imagine it'd have done much damage. Valve train has a lot of strength to it, so likely easily squashed it or spat out pretty quick. I could get a bore scope camera down there to take a look if I get time.
However it is currently hesitant on accelerating and the revs drop a fair bit and dims the lights before accelerating. Not sure if it always has done that or a new thing.
This car maybe on borrowed time if it continues to misbehave. Especially if it dares do it's throttle body fault when I need it to actually work. The next few weeks aren't time for a car to be fucking around with me as I have an incredibly busy time with work and the like ahead.
Took the covers off the battery
Then the battery out
These weird bolt things were a pain to remove. Far too large for any normal screwdriver. I just bashed them around with a wood chisel.
Here is the prize! I assume when they mean connectors under the battery box, they mean the engine ECU connectors
The connectors and pins themselves look in good nick.
Also checked the throttle body connector and that was in good condition too. No flipping idea what caused it. The fault was from a complete throttle body fault on both resistive tracks. Maybe the throttle body is at fault? I don't believe these engines had an issue with them, only the connectors getting corroded.
I did notice that this loom wire was rubbing against the body.
Pulling off the insulation tape and having a closer look seemed to show it was still intact. I wrapped more tape around and used a bit of scrap Dolomite soundproofing material to provide a softer edge.
So I don't know what caused it. I wonder if there is a chaffed section on the engine loom somewhere.
Bit concerning really. Especially as the fault is to rev the engine to 2k and the gearbox to go into 3rd gear (limp home mode). Wouldn't be a pleasant experience it suddenly doing it at motorway speeds or especially if sat in traffic.
Also the intake air temperature sensor is broken. I'm not sure if I caught it or it was already on its way out and it fell to pieces when I was tugging the loom as I was inspecting it for any obvious damage. I took the sensor out entirely and there was broken plastic around the area. Currently the sensor has tigerseal around it to hold it in place. A new sensor is on order.
Upon restarting the car, it really struggled to start. When it did, it was extremely lumpy - almost misfiring. Also a ticking type noise. As the engine warmed up a bit, it's cleared up and seems to run fine.
I think it may have been some of the plastic from the Intake Air Temperature sensor being ingested by the engine? When I removed the sensor, I thought I got all the bits of plastic out of the hole but I wonder maybe some didn't. Only plausible explanation for the rough running. Oops!
I did try restarting it when it was stone cold and it starts happily now. So I don't think there is any ill effects. The plastic was quite brittle and pretty soft, so I can't imagine it'd have done much damage. Valve train has a lot of strength to it, so likely easily squashed it or spat out pretty quick. I could get a bore scope camera down there to take a look if I get time.
However it is currently hesitant on accelerating and the revs drop a fair bit and dims the lights before accelerating. Not sure if it always has done that or a new thing.
This car maybe on borrowed time if it continues to misbehave. Especially if it dares do it's throttle body fault when I need it to actually work. The next few weeks aren't time for a car to be fucking around with me as I have an incredibly busy time with work and the like ahead.
-
- Posts: 13772
- Joined: Sun Apr 14, 2019 11:24 pm
- Has thanked: 1828 times
- Been thanked: 2715 times
Re: The Heirloom Laguna Deux - Trouble lurking
IAT sensor could be causing all number of faults with a modern system trying to compensate for everything.
Does this have an idle air control valve to clean? Have had them fail or stick and cause the random rev to 2000 rpm for no reason on a Renault Clio
Does this have an idle air control valve to clean? Have had them fail or stick and cause the random rev to 2000 rpm for no reason on a Renault Clio